K2355 DI RESIN
NRW37SC mixed bed resin is ready to use, 1:1 chemical equivalent that is highly regenerated in the H+ and OHforms.
NRW37SC resins are manufactured by a proprietary process that achieves the high purity for ultra-pure water applications such as pharmaceuticals, radiation waste, and condensate polishing. The cation and anion used in NRW-37SC are gel resins that are polymerized with a styrene-divinylbenzene matrix and functionalized.
Operating Specifications
| Capacity: Flow Rate: Maximum Pressure: Temperature: |
72 Grains 0.50 GPM (1.9 LPM) 125 PSIG 35-100_ F (2-38_ C) |
General Installation/Operation/Maintenance Requirements
_ Note flow direction of filter.
_ For quick connect fittings, push scratch free tube end into the fitting until it bottoms. Threaded fittings must be wrapped with Teflon_ tape before installation. Install Teflon_ taped fittings and tighten firm. Use two wrenches to firmly tighten tubing.
_ Flush new cartridge with 5 gallons of water prior to use and check for leaks. If leaks occur, check tightness of tubing and fittings. If leaks persist, discontinue use and call your supporting dealer.
_ Replace cartridge when rated capacity (72 Grains) is reached, or when flow becomes too slow.
_ Install in compliance with state and local laws and regulations.
Special Notices
_ The contaminants or other substances removed or reduced by this water treatment system are not necessarily in your water.
_ ADo not use with water that is microbiologically unsafe or of unknown quality without adequate disinfection before or after the system. Systems certified for cyst reduction may be used on disinfected waters that may contain filterable cysts.
Comments are closed