ELF XL DI Resin
Purolite NRW37SC mixed bed resin is ready to use and manufactured by a proprietary process that achieves the high purity for ultra-pure water applications such as pharmaceuticals, radiation waste, and condensate polishing.
Lab Results
| Parameter Grains Grains of Hardness Reduced 800 |
1
Tested using flow rate = 0.5 gpm; pressure = 60 psig; pH = 7.5 ± 0.5; temp. = 20° ± 2.5° C
Operating Specifications
| Capacity: Flow Rate: Maximum Pressure: Temperature: |
800 Grains of Hardness/3 – 6 Months 2.0 GPM 125 PSIG 35-100o F (2-38o C) |
General Installation/Operation/Maintenance Requirements
• For quick connect fittings, push scratch free tube end into the fitting until it bottoms. Threaded fittings must be wrapped with Teflon™ tape before installation. Install Teflon™ taped fittings and tighten firm. Use two wrenches to firmly tighten tubing.
• Flush new cartridge with 5 gallons of water prior to use and check for leaks. If leaks occur, check tightness of tubing
and fittings. If leaks persist, discontinue use and call your supporting dealer.
• Replace cartridge when rated capacity is reached, or when flow becomes too slow.
• Install in compliance with state and local laws and regulations.
Special Notices
• The contaminants or other substances removed or reduced by this water treatment system are not necessarily in your water.
• “Do not use with water that is microbiologically unsafe or of unknown quality without adequate disinfection before or after the system.
Comments are closed